Chuck Yung
EASA Senior Technical Support Specialist

The brushes on a 4-pole, 700 hp DC motor were not wearing at the same rate. In this case, rapid brush wear occurred on two adjacent brush rows - one positive and one negative polarity. The other brushes had minimal wear. Electrical tests found no winding faults, and the air supply was clean. Most of us suspect low current-density when rapid brush wear occurs. A lightly loaded DC motor can "dust" a set of brushes in short order. Changing the brush grade (or removing some of the brushes) will usually solve the problem.

LOGIN TO DOWNLOAD THE ARTICLE

Categories: Brushes, Troubleshooting & failure analysis

Tags: Brushes Armatures

0Upvote 0Downvote

Rate this article:

4.0

Print