Gene Vogel
EASA Pump & Vibration Specialist

The repair of roto-dynamic pumps (pumps with centrifugal and axial flow impellers) requires that, as much as possible, the mechanical condition of the pump be returned to factory specifications. This presentation focusses on critical close fit tolerances and certain surface finish specifications. The best recommendation is always that factory tolerances be used. However, when those factory tolerances are simply not available and the pump must be repaired, service centers rely on general rules of thumb and experience to complete repairs. 

The following concerns will be reviewed: 

• Rolling element bearings
• Sleeve bearings (horizontal)
• VTP bearings
• Impeller-casing wear rings
• Casing rabbets
• VTP motor mounting flange runout and P-flange type motor bases
• Throttle (throat) bushings
• Impeller-shaft fit
• Stage bushings

This summary of data, collected from various service centers, pump manufacturers, parts manufacturers and engineering resources, assembled in one resource, will be helpful to pump repair technicians, supervisors and engineers.

See the related recording and white paper "Pump Repair: Working with Close Tolerance Fits" that was presented at the EASA 2023 Convention.

 

LOGIN TO VIEW THE RECORDING AND DOWNLOAD THE HANDOUT

Categories: Technical topics, Pumps, Pump seals, Impellers, Repair procedures & tips, Webinar recordings

Tags: Pumps Impeller Pump seals Pump repairs

0Upvote 0Downvote

Rate this article:

No rating

Print