Revisit EASA's 2026 Convention & Solutions Expo by buying access to recordings of the general sessions and education events streamed from EASA's website! These recordings provide just over 32 hours of training. Downloadable PDFs of slides and technical papers are included!

This webinar recording shares practical solutions for mechanics and winders to overcome common challenges and streamline their daily work.

A tilted or improperly sized oil standpipe can allow oil to migrate upward along the pipe’s wall when the motor is in operation, leading to leakage, loss of lubrication and potential bearing damage. This issue can be overlooked during assembly or inspection, but a few simple checks can prevent costly problems. 

This recording provides an overview of common different thrust bearing arrangements, with end play guidance tips for each.

Horizontal and vertical motors have uniquely different requirements for endplay, while sleeve bearing machines bring their own challenges. This presentation examines those differences.

This video shows the proper way to lubricate the deep-groove, open ball bearing before assembling a horizontal induction motor.

This video demonstrates the correct way to use an induction bearing heater to install an interference fit ball bearing on a machine shaft.

Revisit EASA's 2024 Convention & Solutions Expo by buying access to recordings of the general sessions and education events streamed from EASA's website! These recordings provide just over 32 hours of training. Downloadable PDFs of slides and technical papers are included!

When repairing centrifugal and axial flow pumps, axial thrust is a concern. An understanding of the causes and the mitigating provisions of various pump designs will help repair technicians to ensure those provisions work properly.

This video walks through the steps to adjust and set end play on a typical vertical hollow shaft pump motor.